Inhaltsverzeichnis
Werbung
Specifications
Maximum sample rate
Maximum input amplifier bandwidth
Input impedance
Maximum input voltage
Input coupling
Vertical resolution
Trigger modes
Trigger level
LCD Graphics
Signal storage
dBm measurement (0dBm= 0.775V)
dBV measurements (0dBV= 1V)
True-rms measurement
Timebase range in 35 steps
Input sensitivity range in 14 steps
Probe calibration output
Supply voltage
Batteries
Charge current for rechargeable batteries
Current consumption current (average)
Operating temperature
Fysical characteristics
Interface to PC
Firmware
Protection
! Modifications reserved. See page 8
72
Aps230 ADVANCED PersonalScope
2x 240MS/s for repetitive signals ( 2x 60MS/s for single shot events)
30MHz ( -3dB ) per channel
1Mohm // 20pF (standard oscilloscope probe)
100Vpeak (AC + DC), 200Vpeak-peak (AC only)
DC, AC and GND (GND for auto zero reference)
8 bit ± 1bit linearity
Run, Normal, Once, Roll mode for 10s/div and slower timebase
Adjustable with positive or negative slope selection
128 x 192 pixels with LED backlight
256 samples per channel, 2048 in roll mode
From –80dB tot +38dB (up to 58dB with X10 probe) ±0.5dB accuracy
From -78dB tot +40dB (up to 60dB with X10 probe) ±0.5dB accuracy
From 0.03mV to 80V (up to 400Vrms with X10 probe) 2.5% accuracy
25ns to 1hour/division
1mV to 20V/division at X1
-
10mV to 200V/div at X10 prope
1,2KHz / 3Vpp
9VDC/ min 500mA regulated adapter
6V / 1800mA battery pack NiMH rechargeable
400mA fast charge (50mA trickle charge)
On: 350mA, with backlight: 400mA, standby current: < 100µA
0 to 50°C (32 to 122°F)
Dim: 230x150x50mm (9x5.9x1.97") Weight: 870g incl. Batteries
Internal optical isolated RS232, 115200Baudrate for screen and data load/set
Upgradable through internet
IEC1010, 600V CATII, pollution degree 1 (IP40)
TM
Werbung
Inhaltsverzeichnis
