Scope Of Delivery; Transport, Assembly And Setup; Assembly - BEAUTY ANGEL C46 sun Gebrauchsanweisung

Information for the operator
10
– Please make the instructions and additional information from the manu-
facturer available to the personnel at their workplace.
– Regularly check your personnel's safety consciousness and awareness
of the risks, taking into account your operating instructions.
– You must ensure that the cleaning intervals are complied with, in particu-
lar cleaning after every session.
– Please ensure that your staff provide your customers with appropriate
advice, in particular regarding application and tanning times, possible
risks and the operation of the device.
– People under 18 may not use the device. Please instruct your personnel
to check the customer's identification in the event of doubt.
2.5

Scope of delivery

Information regarding the scope of delivery is contained in the 'Description'
chapter on page 16.
2.6

Transport, assembly and setup

The device is delivered by a specialist company and assembled and set up by
the manufacturer's own service personnel or by an authorized service com-
pany.
As an operator you are responsible for complying with the on-site ventilation
and electrical requirements at the setup location, see page 11.
2.6.1

Assembly

DANGER!
Personal danger due to electric shock or burns!
– The assembly and electrical connection must comply
with the national regulations.
– The on-site electrical installation must be fitted with an
easily accessible all-pole isolating device (master
switch), complying with overvoltage category III. This
means that each pole must have a contact opening
width complying with the conditions of overvoltage
category III for full isolation.
– If the connection is established via a plug-in connection
then the connection system according to EN 60309
must be utilized.
– Assembly, installation, upgrading or repair of the device
may only be carried out by specially trained and in-
structed personnel.
Information regarding the disassembly and assembly of the device is avail-
able in the separate assembly instructions. These assembly instructions are
intended solely for use by the manufacturer's service personnel or by qualified
specialists authorized by the manufacturer.