Unitest TELARIS 0100-ELEKTROcheck Bedienungsanleitung Seite 77

Measurement function
RCD test
RCD test
RCD test
Phase sequence
Phase sequence
Display
Displays / Error Messages
Comment/Remark
RCD is not in order and has not tripped. Possibly, the
nominal fault current has not been correctly set or the
RCD is defective.
RCD is not in order and has not tripped within 300ms.
Possibly, the nominal fault current has not been cor-
rectly set or the RCD is defective.
RCD is not in order and has already not tripped during
contact voltage test. Possibly, the nominal fault current
has not been correctly set or the RCD is defective.
A clockwise phase sequence is present at measure-
ment sockets L1, L2, and L3.
An anticlockwise phase sequence is present at mea-
surement sockets L1, L2, and L3.
33