Reading The Id Number; Reading Otp Memory; Writing Otp Memory - Siemens MOBY STG Handbuch

R 06.07
4.2.6

Reading the ID Number

Only MOBY D/E/F/U: The function reads and indicates the serial number of the
MDS. The ID number is set at the factory and cannot be changed.
The TagId is displayed in hexadecimal format by the editor in the second line.
The TagId is automatically read with the "MDS read/write/erase" functions.
4.2.7

Reading OTP Memory

Only MOBY U: The function reads the complete OTP memory (16 bytes).
Note
When the mode "MDS complete" was selected in the "Read/write"
field in the "Extras/Addresses Setup/..." menu, the function "MDS/
Read" is started immediately without any further questions. The
entire MDS is always processed.
4.2.8

Writing OTP memory

Only MOBY U: The function writes the complete OTP memory (16 bytes).
Note
The OTP memory can be written only once. Before execution, you
are asked again whether you really want to execute the function
since this action is irreversible.
STG Hand-Held Terminal
(5)J31069-D0126-U001-A5.2-7418
The "MOBY D/E/F/I/U" Programs
E-25