Using The Moby U Antenna - Siemens MOBY STG Handbuch

Using the STG
3.3

Using the MOBY U Antenna

The MDS functions (e.g., read, write, initialize) are not triggered on the STG U
hand-held terminal until the communication button is pressed.
The "Menu" button is used to select the appropriate MDS function. The follo-
wing message appears on the display.
Wait for ENTER of antenna
ESC to cancel
Then point the STG U hand-held terminal to the desired MDS Uxxx and press
the communication button.
After the communication button is pressed, the antenna goes on, the MDS
function is executed, and the antenna goes off again. As long as the antenna is
active, the LED for communication is yellow. It takes approx. 2 seconds to turn
on the antenna. Depending on the amount of data and the recognition of the
MDS, turn on takes a minimum of approx. 3 seconds.
STG U hand-held terminal
Note
The LED communication lights up red when the charging status of
the batteries is not sufficient for communication.
E-12
LED for communication
Communication button
STG Hand-Held Terminal
(5)J31069-D0126-U001-A5.2-7418
R 06.07