Address Setup - Siemens MOBY STG Handbuch

The "MOBY D/E/F/I/U" Programs
4.5.4

Address Setup

This function defines the call of the "read/write MDS" commands.
S Start address +
S Read/Write
E-32
Length: Entry of the MDS address for the read/
write command uses a start address
and the length of the data to be
processed.
End address: Entry of the MDS address for the read/
write command uses a start address
and an end address.
Switching from "block" to "complete MDS" takes place
here. This setting affects the default setting for
execution of an MDS command.
Block: When an MDS is read/written, the
currently active area is always indicated
as the area to be read/written.
Complete MDS: When an MDS is read/written, the
entire MDS is always processed.
The read/write function is started
immediately. Partial MDS areas cannot
be entered.
STG Hand-Held Terminal
(5)J31069-D0126-U001-A5.2-7418
R 06.07