Reading The Mds; Writing The Mds; Erasing/Initializing The Mds; Reading The Id Number - Siemens Moby J31069-D0126-U001-A6-7418 Bedienungsanleitung

The "MOBY D/E/I" Programs
4.2.2

Reading the MDS

A data block with a start and end address, which can be defined as desired,
can be read from the MDS. If the same value is entered for the start and end
address, only one block can be read from the MDS. The address area is indi-
cated in another screen for confirmation.
Note
If mode "Complete MDS" was selected in the read/write field of the
menu "Extras/Address Setup/...," the "MDS/read" funktion is started
immediately without asking any questions. The complete MDS is al-
ways processed.
4.2.3

Writing the MDS

A data block can be written to the MDS. The data block which is valid in the
editor is indicated as the default for each write access. The default length or
end address can still be changed to another value during the write-access.
4.2.4

Erasing/Initializing the MDS

The "erase/initialize MDS" function is used to write the entire MDS with a
certain value in a very short time. The erasure value can be entered in a
subsequent menu. After the deletion function has been performed, the memory
in the editor is also erased with the value which was entered. With the MOBY I,
the correct size of the MDS memory must be set (Extras/MOBY I Setup) before
this function is performed.
4.2.5

Reading the ID Number

Only MOBY D/E: The function reads and indicates the serial number of the
MDS. The ID number is set at the factory and cannot be changed.
The TagId is displayed in hexadecimal format by the editor in the second line.
The TagId is automatically read with the "MDS read/write/erase" functions.
E-20
STG Hand-Held Terminal PRO
(5)J31069-D0126-U001-A6-7418
R 05/07