Setting And Starting A Programme - Electrolux ESL6362LO Benutzerinformation

30 www.electrolux.com
4. Add the detergent. If you use multi-
tablets, activate the option Multitab.
5. Set and start the correct programme
for the type of load and the degree of
soil.
9.1 Using the detergent
D
A
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent in the compartment (D).
4. Close the lid. Make sure that the
release button locks into position.
9.2 Setting and starting a
programme
The Auto Off function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
A B
30
20
C
B D
30
20
• 5 minutes after the completion of the
• After 5 minutes if the programme has
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
3. Press the button related to the
The display shows the programme
duration.
4. Set the applicable options.
5. Close the appliance door to start the
Starting a programme with delay
start
1. Set a programme.
2. Press
The delay indicator comes on.
3. Close the appliance door to start the
C
While a countdown is running it is possible
to increase the delay time but not to
change the selection of the programme
and options.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. When you
close the door, the appliance continues
from the point of interruption.
programme.
not started.
appliance. Make sure that the
appliance is in programme selection
mode.
programme you want to start.
programme.
again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
countdown.
If the door is opened for more
than 30 seconds during the
drying phase, the running
programme will end.