Setting And Starting A Programme - Electrolux GA60SLISCN Benutzerinformation

16 www.electrolux.com
9.1 Using the detergent
A
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent (gel, powder or
tablets) in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
For information about the
detergent dosage, refer to
the manufacturer's
instructions on the
packaging of the product.
Usually, 20 - 25 ml of gel
detergent is adequate for
washing a load with normal
soil.
The upper ends of the two
vertical ribs inside the
compartment (B) indicate
the maximum level for filling
the dispenser with gel (max.
30ml).
B
C
9.2 Setting and starting a
programme
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
2. Close the appliance door.
3. Press repeatedly until the
indicator of the desired programme is
on.
The display shows the programme
duration.
4. Set applicable options if desired.
5. Press to start the programme.
• The indicator of the running phase
is on.
• The programme duration counts
down in minutes.
Starting a programme with
delay start
1. Set a programme.
2. Press repeatedly until the display
shows the desired delay time (from 1
to 24 hours).
3. Press to begin the countdown.
• The indicator
• The remaining time counts down
in hours. The final hour is
displayed in minutes.
When the countdown is complete, the
programme starts and the indicator of the
running phase is on. The indicator
off.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
is on.
is