Setting And Starting A Programme; Cancelling The Programme - Electrolux GA60GLICSP Benutzerinformation

9.3 Setting and starting a
programme
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
2. Close the appliance door.
3. Press repeatedly until the
indicator of the desired programme is
on.
The display shows the programme
duration.
4. Set applicable options if desired.
5. Press to start the programme.
• The indicator of the running phase
is on.
• The programme duration counts
down in minutes.
Starting a programme with
delay start
1. Set a programme.
2. Press repeatedly until the display
shows the desired delay time (from 1
to 24 hours).
3. Press to begin the countdown.
• The indicator
• The remaining time counts down
in hours. The final hour is
displayed in minutes.
When the countdown is complete, the
programme starts and the indicator of the
running phase is on. The indicator
off.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
is on.
is
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
Cancelling the delay start while
the countdown operates
When you cancel the delay start, you
have to set a programme and options
again.
Press and hold simultaneously
until the appliance is in programme
selection mode.

Cancelling the programme

Press and hold simultaneously
until the appliance is in programme
selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is complete, the
Auto Off function switches the appliance
off automatically.
All buttons are inactive except for the
on/off button.
Close the water tap.
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was
not started.
ENGLISH 17
and
and