Autoreset; Simatic Fs400 3Rg7845 - Diagnostics Software - Siemens SIMATIC FS400 Anleitung

11.3

AutoReset

After an error or a fault has been detected and indicated, with the exception of the
locking error/fault, a restart follows automatically in the
about 10 seconds for the transmitter
about 10 seconds for the receiver
for the device in question. If the error or fault is then no longer present, the machine/
application can be started again. The temporary error signal then gets lost.
* The receiver is not automatically reset after 10 seconds with locking errors (F6, F8, F10, F25,
F26, F30, F32, F33, F34, F35, F37). The receiver goes instead to the error locking status, from
which it can only come out of by switching the supply voltage off and back on again.
11.4 SIMATIC FS400 3RG7845 – Diagnostics Software
SIMATIC FS400 3RG7845 diagnostics software is also available. The software that
can be run
SIMATIC FS400 3RG7845 light curtains and light grids by displaying the interrupted
beams. (See accessories, Chapter 13.1.2)
190
from WINDOWS 3.1 accelerates the alignment of the