Troubleshooting; Possible Cause - Scheppach Dts215 Original Bedienungsanleitung

13.

Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your ma-
chine failing to work properly. If you cannot localise and rectify the problem with this, please contact
your service workshop.
Fault
Power tool does not
start
Power tool does not
operate with full power
Poor operation results
Considerable dust
formation
34 | GB

Possible cause

Power supply interrupted
Power cord or plug defective
Other electrical defect of the
power tool
Extension cord too long and/or
cross-section too small
Power supply (e.g. generator)
voltage too low
Power tool worn out
Sanding plate worn out
Dust extraction not connected/
switched on
www.scheppach.com
Remedy
Check power supply by connecting
another power tool
Have an electrician check the tool
Have an electrician check the tool
Use extension cord with permissible
length and/or adequate cross-section
Connect power tool to an appropriate
power supply
Replace insertion tool
Have sanding plate replaced
Connect/switch on dust extraction