Troubleshooting - Scheppach 5903804901 Originalbetriebsanleitung

- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.

14. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your product failing
to work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause
Power tool does Power supply interrupted
not start
Power cord or plug defective
Other electrical defect of the power tool
Power tool does Extension cable too long and/or cross-sec-
not operate with tion too small
full power
Power supply (e.g. generator) voltage is
too low
Poor operation Tool attachment worn out
results
Grinding disc worn
Considerable Brush edge worn out
dust formation
Dust extraction not connected/switched on
• If the manufacturer delivers a new electrical device
to a private household, the manufacturer can ar-
range for the free collection of the old electrical de-
vice upon request from the end user. Please contact
the manufacturer's customer service for this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Check power supply by connecting another
power tool
Have an electrician check the tool
Have an electrician check the tool
Use extension cable with permissible length
and cross-section
Connect power tool to an appropriate power
supply
Have tool attachment replaced
Have the grinding disc replaced
Have brush edge replaced
Connect / switch on dust extraction
www.scheppach.com
Remedy
GB | 31