1.
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Failure to comply with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system due to failure to
observe the national electrical requirements and
regulations
Note:
The operating manual is part of the product and contain
important information for safe, proper and economical
operation. Please also observe the applicable national
regulations. Read all operating and safety instructions
carefully before use and only use the product as de-
scribed. Keep the manual and pass it on when you give
the product to someone else.
2. Device description (Fig. 1 - 14)
1.
Transport handle
2.
Pressure switch
3.
Quick coupling (regulated compressed air)
4.
Pressure gauge (set pressure can be read off)
5.
Pressure regulator
6.
Pressure gauge (vessel pressure can be read off)
7.
Quick coupling (unregulated compressed air)
8.
Pressure vessel
9.
Foot (2x)
10. Drain screw for condensate
11. Wheel (2x)
12. Oil drain screw / Oil sight glass
13. Compressor pump
14. Air filter
15. Oil plug
16. ON/OFF switch
17. Safety valve
18. Oil filler hole
24 | GB
19. Screw (wheel)
20. Washer (wheel)
21. Spring washer (wheel)
22. Nut (wheel)
23. Screw (foot)
24. Washer (foot)
25. Nut (foot)
26. Spacer sleeve
3. Scope of delivery
• 2x air filter
• 2x feet
• 2x wheels
• 1x assembly material
• 1x oil plug
• 1x oil bottle
• 1x operating manual
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, keep the packaging until the expiry of
the warranty period.
m ATTENTION!
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
4. Proper use
The compressor is used to generate compressed air
for pneumatically powered tools that can be operated
with an air rate of up to 294 l/min. (e.g. tyre inflators, air
blow guns, paint spray guns).
The compressor may only be operated in a dry and
well ventilated indoor space.
The machine may only be used in the intended man-
ner. Any use beyond this is improper. The user/oper-
ator, not the manufacturer, is responsible for damages
or injuries of any type resulting from this.
www.scheppach.com