Scheppach HC50 Originalbetriebsanweisung Seite 75

Unpacking
Due to modern series production it is improbable that
your compressor has any defects or that a part is miss-
ing. Should you note a fault, however, do not switch the
machine on before the parts are replaced or the fault has
been remedied. Not observing this instruction can lead to
serious injuries.
Assembly
Handle, Fig. 2
1 Get the two threaded pins from the accessory bag and
put them into the threaded holes in the handle tubes.
2 Push the two handle ends into the fixing holes.
3 Tighten the screws to fix the handle in place.
Wheels, Fig. 3
1 To secure the wheels (12), first place a disc with the
wheel bolts through the wheel. Then, add a disc and
a hex-nut on the inside of the wheel. Now tighten the
nut by hand to the greatest extent that will allow the
wheel to still rotate.
2 Slide the wheel through the clip under the tank.
3 Then fasten it with a disc, a safety glass, and a nut and
tighten them together.
4 Repeat this process for the second wheel.
Rubber feet, Fig. 4
Fix the rubber feet to the bracket on the front of the tank
using the screws, washers and nuts supplied.
international 75