Technical Data; General Information - Scheppach 1905501902 Originalanleitung

Technical Data:

Art. No.
Drive
Power consumption P1
Output power P2
Engine speed
Operating mode
Phase inverter
Phasenwender
Dimensions L/W/H
Height with lowered cylinder
Splitting power
Forward speed 1 (fast traverse)
Forward speed 2
Return speed
Weight
Hydraulic oil capacity
Characteristic noise values
The noise emission values, determined ac-
cording to EN 23746 for the sound power level
or EN 31202 (correction factor k3 calculated
D GB
according to Appendix A.2 of EN 31204) for
the sound pressure level at the workplace, and
based on the working conditions listed in ISO
7904 Appendix A, are as follows:
Sound power level at the workplace in dB
Idle LWA / Working LWA dB (A)
60/77
We wish you much joy and success in working
with your new machine.
Note:
The manufacturer of this equipment shall not be
liable in accordance with the applicable product
liability law for damage caused to or by this
device through:
• Improper treatment,
• failure to comply with the operating instruc-
tions,
• Repair by unauthorised personnel,
• installation and replacement of non-original
parts,
• improper use,
• Failure of the electrical system due to non-
compliance with electrical requirements
and VDE specifications 0100, DIN 57113 /
VDE0113.
We recommend:
Read the entire operating instructions before
assembly and getting started with the device.
This operating manual should help you become
familiar with your machine and use it as inten-
ded.
The operating manual includes important
Technical data
Sound pressure level at the workplace in dB
Idle LpAeq / Working LpAeq dB (A)
66/75
The specified values are emission levels and
do not necessarily represent safe workplace
values. Although there is a correlation between
emission and immission levels, it cannot be
inferred with certainty whether or not additional
precautions are necessary. Factors which affect
the current immission level at the workplace

General Information

information on how to work safely, correctly and
economically with the machine and how to avoid
hazards, save repair costs, reduce downtimes
and increase the reliability and service life of the
machine.
In addition to the safety regulations of this
operating manual, you must follow the national
provisions applicable to the operation of the
machine.
Keep the operating manual close to the machi-
ne, in a plastic cover protected against dirt and
moisture. It must be read by every operator be-
fore starting work and carefully followed. Work
at the machine may be done only by persons
who are instructed on using the machine and the
associated hazards. The minimum age specified
should be observed.
18
Ox 5-1310
19055 01902
Electrical Motor
kW
kW
1/min
S6 40 %
mm 1150x1050x2500
mm
t
cm/s
cm/s
cm/s
kg
l
include the nature of the working space, other
noise sources, such as the number of machines
and other adjacent operations. The allowed wor-
king values may vary from country to country.
Nevertheless, the information should enable the
user to make an assessment of hazard and risk.
• Check all parts for any transportation
damage after unpacking them. In case of
complaints, the supplying carrier must be
notified immediately. Later claims will not
be accepted.
• Check the shipment for completeness.
• Familiarise yourself with the device before
using it by referring to the operating ma-
nual.
• Use only original parts for accessories,
wear parts and spare parts. You will recei-
ve spare parts from your specialist dealer.
• Indicate our article numbers as well as type
and model of the device in your orders
4,5
4,1
1400
ja
ja
1900
13
12,35
5
7
262
18