Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
moving at full speed. Press the saw slowly
and carefully, but firmly, into the material.
Next, push the saw forwards along the sawing
line. Never pull the saw backwards.
•
After sawing, lift the saw upwards and turn it
off. If a lot of sawdust has been created, allow
the saw to continue running until all the dust
has been removed.
Tips for cutting out shapes:
•
If the hole will later be covered, for
example by a fan filter, then the cuts in the
corners can overlap so that the piece
easily falls out.
•
If the hole remains visible, it is better not
to overlap the cuts in the corners. Since a
round blade is used, the piece that is to be
cut out will not fall out immediately. The
corners will have to be finished with a
knife. If the material is thin and it is not
important what the back looks like, then
the piece to be cut out can be pushed out.
•
If it is possible to saw at the back, then the
piece which is to be cut out can be
marked with an overcut margin. The piece
can then be sawn from the back so that
the corners look nice at the front. A scale
of margins is given in the specifications.
N.B.: It is not possible to cut pieces out of some
hard materials.
Sawing hard or rough materials
Warning! Never saw material where
harmful substances are released, such
as PTFE or asbestos.
Sheet metal
•
Always set the sawing depth to at least 1 mm
greater than the thickness of the material so
that the saw does not slip. Place a piece of
cardboard under the metal sheet.
•
Remove any irregularities and rust which may
hinder the saw.
•
Beeswax or furniture polish applied to the saw's
base plate will make it easier to saw metal.
•
Do not saw steel or galvanized steel.
•
Pause every 2 minutes when sawing metal.
Ceramic tiles and slate
•
Use a suitable blade. It is necessary to use
dust extraction, because the dust which is
Ferm
created can hinder the movement of the
protective cover.
•
Place protective tape or PVC tape on the
base plate or on the object to be sawn. This
makes it easier to saw and protects the tiles
against becoming scratched.
Plasterboard
•
As an exception, the saw may be used to cut
plasterboard, but only with suitable dust
extraction. Dust can hinder the movement of
the protective cover.
N.B.: Practice sawing wood before trying
something more complicated, such as metal or
some types of plastic. More force is required
to hold the object to be sawn and you may
sometimes have to use clamps to keep the object
in place.
Dust extraction
The Precision Circular Saw is a powerful saw. A
lot of dust will be produced when sawing. Since
the blade is fully enclosed, it is necessary to
extract the dust.
•
An industrial vacuum cleaner or a household
vacuum cleaner can be attached to the saw's
dust extraction pipe with the aid of a dust
extraction kit.
•
Before use, make sure the hose fits exactly
onto the metal clip.
•
Remove the plug from the socket before
connecting the hose. Push the hose with the
metal clip onto the dust extraction pipe as far
as the lath on the saw. Make sure the
protective cover can still move freely. If
necessary, use tape to secure the hose in
position.
•
Make sure the vacuum cleaner is suitable for
use with an electrical machine. In general,
household water and dust vacuum cleaners
are suitable.
•
It is recommended to use dust extraction
when a lot of sawing is to carried out, because
less breaks will then be required to clean the
saw and the surroundings.
•
It is necessary to extract the dust when
sawing dangerous materials, such as
hardwood, MDF and ceramics.
•
It is recommended to extract dust if you wish
to keep the work area clean.
•
It is necessary to extract the dust if the
EN
13
Werbung
Inhaltsverzeichnis
