Electrical Connections - Vevor Rtp22Ws115V Originalanleitung

GROUNDING CONDUCTOR AND/OR GROUNDING TYPE ATTACHMENT
PLUG, TO REDUCE THE RISK OF ELECTRICAL SHOCK, BE CERTAIN THAT
IT IS CONNECTED TO A PROPERLY GROUNDED GROUNDING TYPE
RECEPTACLE.
IN ANY INSTALLATIONS WHERE PROPERTY DAMAGE AND/OR PERSONAL
INJURY MIGHT RESULT FROM AN INOPERATIVE OF LEAKING PUMP DUE
TO POWER OUTAGES, DISCHARGE LINE BLOCKAGE, OR ANY OTHER
REASON, A BACKUP SYSTEM(S) AND/OR ALARM SHOULD BE USED.
SUPPORT PUMP AND PIPING WHEN ASSEMBLING AND WHEN INSTALLED.
FAILURE TO DO SO MAY CAUSE PIPING TO BREAK PUMP TO FAIL, MOTOR
BEARING FAILURES, ETC.
INSTALLATION
1. Before installing pump, allow air conditioner to cycle several times, collecting
condensate in a separate container to help flush any residual oils that may remain
in the system.
2. Carefully unpack the pump. Remove the cardboard packing from the motor
cover air slots. Carefully slide the packing away from the pump. This packing is
used to prevent switch movement during shipment (Figure 1).
3. Mounting the pump: the tank has two slots provided to mount the unit. The slots
are located on the ends of the tank (Figure 5). The unit should be mounted either
on the side of the air conditioner unit or nearby wall. Pump must be level and the
inlet must be below the coil drain. Conduit fittings are not compatible with the
plastic pump housing.
4. The pump should not be installed in a manner that will subject it to splashing or
spraying.
5. This pump is not intended for use inside air plenums.

ELECTRICAL CONNECTIONS

WARNING
1. Shut off electrical power at fuse box before making any connections. All wiring
must comply with local codes.
- 4 -