Rear Panel - Omnitronic cp-30p Bedienungsanleitung

Rear Panel

13
15
No. Element
13 Power input with fuse holder
14 Antenna connection
15 DC24V IN terminals
16 SPEAKER OUTPUT terminals
17 TEL INPUT terminals
18 MOH OUTPUT terminals
19 MIC 2/LINE 1 input
20 MIC 3/LINE 2 input
21 CONTROL DIP switches
22 MIC 1 input
23 LINE 3 input
24 LINE 4 input
25 OUT output
14
16 17
Function
Used to plug in the supplied power cable. Only use fuses of the same
rating and power. The correct fuse value is specified on the rear panel.
Only replace the fuse when the unit is disconnected from the mains.
Connection for the included antenna. Put the antenna in a vertical position
for FM reception.
Screw terminals for a 24 V emergency power
• COM: common ground connection for all speakers
• 4Ω/8Ω/16Ω: for connecting 4-16 Ω speakers
• 70V/100V: for connecting 70 V and 100 V speakers
Connection for telephone systems with line level output or another line
signal source for important announcements. To enable the priority circuit
set DIP switch 4 to the lower position.
To feed music on your telephone system for people waiting to be
answered
Unbalanced 6.3 mm jack for connecting a dynamic microphone or a line
level audio device
Unbalanced 6.3 mm jack for connecting a dynamic microphone or a line
level audio device
• 1 and 2: line level (lower position) or microphone level (upper position)
• 3: phantom power on (lower position) or off (upper position)
• 4: priority enabled for telephone input (lower position) or MIC 1 input
(upper position)
Balanced XLR jack for connecting a microphone. For a phantom-powered
microphone set DIP switch 3 to the lower position. To enable the priority
circuit set DIP switch 4 to the upper position
RCA jacks for connecting audio units with line level (e.g. CD player)
RCA jacks for connecting audio units with line level (e.g. CD player)
RCA jacks for the mixed signal to connect, e.g. an additional amplifier
18 19 20 21
21
22 23 24 25