Operating Determinations - Omnitronic cp-30p Bedienungsanleitung

3

OPERATING DETERMINATIONS

The PA mono mixing amplifiers of the CP series have been specially designed for the use in 100 V PA
systems. PA speakers with 70 V and 100 V audio transformers or 4-16 Ω speakers can be connected. It is
possible to connect microphones and units with line level to the six inputs which can be mixed with each
other. Microphone channel 1 is equipped with a priority function which reduces the volume of the other signal
sources in case of an announcement. Additional screw terminals connect a telephone system. The PA
amplifiers are provided with a built-in audio player for MP3 files from USB storage devices and SD(HC) cards
as well as wireless music streaming from your Bluetooth devices such as smartphones, tablets and
notebooks. An IR remote control is included for convenient control of the audio player.
Power Supply
This product is allowed to be operated with an
alternating current of 230 V AC, 60 Hz and was
designed for indoor use only. The occupation of the
connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected! If the device will be
directly connected with the local power supply network,
a disconnection switch with a minimum opening of 3
mm at every pole has to be included in the permanent
electrical installation. The device must only be
connected with an electric installation carried out in
compliance with the IEC standards. The electric
installation must be equipped with a Residual Current
Device (RCD) with a maximum fault current of 30 mA.
Installation
Do not shake the device. Avoid brute force when
installing or operating the device. When choosing the
installation spot, please make sure that the device is
not exposed to extreme heat, moisture or dust. There
should not be any cables lying around. You endanger
your own and the safety of others!
Ambient Conditions
This device must never be operated or stockpiled in
surroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity
can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that
the device is never exposed to the direct smoke jet and
is installed in a distance of 0.5 meters between smoke
machine and device. The ambient temperature must
always be between -5° C and +45° C. Keep away from
direct insulation (particularly in cars) and heaters. The
relative humidity must not exceed 50 % with an ambient
temperature of 45° C. This device must only be
operated in an altitude between -20 and 2000 m over
NN. The ambient contamination must never exceed
level 1 and must not be conducting, only dry. Never use
the device during thunderstorms. Over voltage could
destroy the device. Always disconnect the device
during thunderstorms.
Transport
Please use the original packaging if the device is to be
transported.
Cleaning
Never use solvents or aggressive detergents in order to
clean the device! Rather use a soft and damp cloth.
International
L
N
Operation
Operate the device only after having familiarized with its
functions. Do not permit operation by persons not
qualified for operating the device. Most damages are
the result of unprofessional operation!
Serial Barcode
Never remove the serial barcode from the device as
this would make the guarantee void.
Modifications and Guarantee
Please note that damages caused by manual
modifications on the device or unauthorized operation
by unqualified persons are not subject to warranty. If
this device will be operated in any way different to the
one described in this manual, the product may suffer
damages and the guarantee becomes void.
Furthermore, any other operation may lead to dangers
like short-circuit, burns, electric shock, etc.
Avoiding Hearing Loss
By operating amplifying systems, you can produce
excessive sound pressure levels that may lead to
permanent hearing loss. Please refer to the
explanations under "Legal instructions".
Public and Industrial Use
Operating an amplification system in public or industrial
areas, a series of safety instructions have to be
followed that this manual can only give in part. The
operator must therefore inform himself on the current
safety instructions and consider them.
EU Declaration of Conformity
Steinigke Showtechnic GmbH hereby declares that this
product CP-30P/CP-60P/CP-120P is in compliance with
the essential requirements and other relevant
provisions of Directive 2014/53/EU. The complete
Declaration of Conformity can be found at
www.steinigke.de.
18