Rear Panel - Omnitronic MAVZ Serie Bedienungsanleitung

Rear panel

17
19
Nr. Element
Mains fuse
17
18
100V ZONE OUTPUT terminals
Mains cable
19
20 SPEAKER OUTPUT terminals
Line output
21
LINE 4 input
22
LINE 3 input
23
24 MIC 3/LINE 2 input
25 MIC 2/LINE 1 input
26 DIP switches
27 MIC 1 input
18
20
Funktion
Only replace the fuse when the unit is disconnected from the mains. Only
use a fuse of the same rating and power. The correct fuse value is specified
on the rear panel.
Terminals for zones 1 to 6 for connecting 100 V speakers.
For connection to a mains outlet.
• 70V/100V: for connecting 70 V and 100 V speakers
• 4Ω/8Ω/16Ω: for connecting 4-16 Ω speakers
• COM: common ground connection for all speakers
Stereo RCA output for connection to units with line level inputs (e.g. mixer,
amplifier).
Stereo RCA inputs for connecting units with line level (e.g. CD player).
Stereo RCA inputs for connecting units with line level (e.g. CD player).
Unbalanced 6.3 mm jack for connecting a dynamic microphone or a line
level audio device.
Unbalanced 6.3 mm jack for connecting a dynamic microphone or a line
level audio device.
• 1 and 2: line level (upper position) or microphone level (lower position) at
inputs MIC 3/LINE 2 or MIC 2/LINE 1
• 3: phantom power on (upper position) or off (lower position) at input MIC 1
• 4: priority circuit on (upper position) or off (lower position) at input MIC 1
Balanced XLR jack for connecting a microphone. For a phantom-powered
microphone set DIP switch 3 to the upper position. To enable the priority
circuit for this input, set DIP switch 4 to the upper position. Then the level of
the other inputs is attenuated when an announcement is made via this input.
20 • EN
21 22 23 24 25 26
27