Preparing The Device / Filling The Fresh Water Reservoir; Cleaning The Carpet - Cleanmaxx Z 06805 Gebrauchsanleitung

Preparing the Device / Filling the Fresh Water Reservoir

CAUTION!
❐ Only fi ll the fresh water reservoir with the enclosed cleaner or with commercially-available
carpet cleaners for carpet washers.
❐ Do not use any high-foaming cleaners as an excessive amount of foam impairs the functioning
of the device. If unsuitable cleaning agents are used, the warranty claim expires.

Cleaning the Carpet

CAUTION!
❐ Do not use the device as a conventional vacuum cleaner.
❐ Always make sure that there is no risk of the device tipping over. The water could leak out
of the water reservoirs. To stow the device, position the handle in an upright position so
that it locks into place.
❐ Never leave the device on when unattended.
❐ Turn off the device before you remove the water reservoirs.
❐ Do not excessively wet the carpet.
1. Determine where you want to start and stop cleaning without stepping on the area of the
carpet that was just cleaned. We recommend that right-handed persons start on the right
carpet border and left handed persons start on the left carpet border. Cleaning solution may
leak out of device once it is deactivated. For this reason, have a cloth laid out that you can
place the device on after use.
1. Hold the fresh water reservoir (6) by the handle and pull up the
unlocking lever (5). The reservoir is released from the locking
mechanism.
2. Remove the fresh water reservoir from the device.
3. Unscrew the ring cap on the bottom of the reservoir and
remove the valve together with the water hose.
4. Fill some carpet cleaner into the reservoir. Please note the
dosing instructions of the carpet cleaner.
5. Fill the fresh water reservoir up to the MAX fi lling line with
warm water (max. 40 °C). Preferably use distilled water to
prevent calcifi cation.
6. Then close the reservoir using the valve and ring cap.
7. Insert the fresh water reservoir into the centre piece (13).
20