Installation; Packaging; Handling And Transport; Installation Of The Machine - Promac 335E Bedienungsanleitung

335E
4.

Installation

The procedures described below must be performed by qualified and authorized personnel.
4.1.

Packaging

When unpacking, remove each component from the
machine, check its general condition, and then proceed with
assembly.
Check that the machine is clean. The machine is delivered
4.2.

Handling and transport

Given the weight (85 kg) and dimensions of the machine, handling and installation must be carried out using appropriate means.
4.3.

Installation of the machine

Installation environment:
Power supply voltage in accordance with the machine's specifications
•
Ambient temperature between +5°C and +35°C
•
Relative humidity not exceeding 90%
•
Sufficient ventilation at the installation site
•
Work area sufficiently lit for safe working: lighting must be 500 LUX
•
Consider the location of the machine in the room; it must allow for easy movement and maneuvering. Maintain a minimum distance
of 800 mm between the rear of the machine and the wall.
4.4.

Electrical connection

Electrical work must be carried out by qualified personnel authorized to perform low-voltage electrical work.
Ensure that the supply voltage of the installation corresponds
to that of the machine.
Connect using the power cable. The socket must comply with
the "EN 60309-1" standards.
Check that the power outlet of the installation is compatible
with the plug of the appliance.
Check that the electrical installation to which the machine
will be connected is properly earthed in accordance with
current safety standards.
We remind the user that there must always be a
magnetothermal protection device upstream of the electrical
installation to protect all conductors against short circuits
and overloads.
This protection must always be selected based on the
Use of the device with a damaged cable is strictly prohibited.
Regularly check the condition of the power cord, switches, and cable gland.
Use a cable reel with a cross-section and length appropriate for the power of the device, and unroll it completely.
Electrical connections and extension cords must be protected from splashes and kept on dry surfaces.
Do not remove the plug from the power outlet by pulling on the cord; pull only on the plug.
12
with the ground parts coated with a protective anti-rust oil.
If the product does not appear to be in good condition or if
any parts are broken or missing, contact your dealer.
Keep the instruction manual for future reference.
electrical characteristics of the machine, as specified on the
nameplate:
• Voltage: 400 V three-phase
Current: 3.6 A
•
Motor power: 1.1 kW
•
Frequency: 50 Hz
•
Connect an approved electrical plug (NF EN 60309-1) to the
end of the band saw's power cable in accordance with
current regulations. Insert the yellow-green protective
conductor into the corresponding terminal marked with the
earth symbol.