VOLTCRAFT V-CHARGE 80GPS Bedienungsanleitung Seite 83

Use the buttons "INC" or "DEC" to select a different rechargeable battery programme; use the button
"ESC/MODE/STOP" to return to the main menu.
• If the value for the charging current must be changed, push the "START/ENTER" button. The charging current
flashes. Change the charging current using the buttons "INC" and "DEC". Keep the respective button pressed for
quick adjustment.
The maximum possible charging current depends on the battery type and number of cells. The maximum
charging power is 80 W.
Confirm the set charging current with the "START/ENTER" button.
• The number of the cells in the lower right of the display flashes. Set the number of the cells with the buttons "INC"
and "DEC". Keep the respective button pressed for quick adjustment.
Confirm the number of the cells by pressing the "START/ENTER" button.
• When no display is flashing anymore, start charging by keeping the "START/ENTER" button pushed (approx.
3 seconds).
• The charger now examines the connected rechargeable battery. In case
of an error, a warning signal is output and the corresponding information is
displayed. You can stop the warning signal by pressing the "ESC/MODE/
STOP" button. You then return to the previous configuration menu.
If no error is found, e.g. the display shown on the right will appear.
The "S" value indicates the cell number that you have set in the menu (in
the example a 6-cell lead battery).
The "R" value indicates the cell number that the charger has recognised (in
the example also a 6-cell lead battery).
If these two numbers do not match, please check the settings on the charger and the battery itself. It may
be that the rechargeable battery has been completely discharged, or a cell may be faulty. In this case, the
battery should not be charged, as there is a risk of fire and explosion!
You can return to the previous configuration menu using the "ESC/MODE/STOP" button.
• If the two cell numbers match, briefly push the "START/ENTER" button.
• Charging process starts. The display will show various information on the
current charging progress.
At the upper left, the rechargeable battery type and the cell number are dis-
played ("Pb06" = lead battery with 6 cells); the charging current is shown in
the upper middle and the current rechargeable battery voltage at the upper
right.
The lower left shows the current rechargeable battery programme, the middle the elapsed charging time and the
charged capacity in mAh is displayed to the right of this.
BATTERY CHECK
WAIT...
S: 6SER R: 6SER
CANCEL(EXIT)
S: 6SER R: 6SER
CONFIRM(ENTER)
Pb06 1.0A 12.32V
CHG 022:45 00690
83