VOLTCRAFT V-CHARGE 80GPS Bedienungsanleitung Seite 81

• Use the buttons "INC" or "DEC" to select the desired order ("C>D" = Charge + subsequent discharging; "D>C" =
Discharge + subsequent charging).
• Briefly push the "START/ENTER" button; the charging current flashes. Change the charging current using the
buttons "INC" or "DEC". Keep the respective button pressed for quick adjustment.
• Briefly push the "START/ENTER" button; the discharging current flashes. Change the discharging current using
the buttons "INC" or "DEC". Keep the respective button pressed for quick adjustment.
• Briefly push the button "START/ENTER"; the number of cycles flashes (how often the currently set sequence of
charging/discharging or discharging/charging is performed).
• Set the cycle number with the buttons "INC" and "DEC" (1 - 5 cycles are possible). Push the "START/ENTER"
button briefly then to confirm the setting. The display stops flashing.
• To start cycle programme, keep the "START/ENTER" button pressed for longer (approx. 3 seconds).
• The charger now examines the connected rechargeable battery. In case
of an error, a warning signal is output and the corresponding information is
displayed. You can stop the warning signal by pressing the "ESC/MODE/
STOP" button. You then return to the previous configuration menu.
If no error is found, e.g. the display shown on the right will appear.
The rechargeable battery type is shown in the upper left, the upper middle
shows the charging or discharging current and the upper right the current
rechargeable battery voltage.
The lower left shows the selected cycle programme ("C>D" = Charge/discharge, "D>C" = Discharge/charge),
the middle shows the elapsed charging or discharging duration and the right next to it the charged or discharged
capacity in mAh.
• After completion of the cycle programme, an audio signal is emitted (if it has not been turned off).
To interrupt the cycle programme, push the button "ESC/MODE/STOP".
BATTERY CHECK
WAIT...
NiMH 2.0A 7.42V
C>D 022:45 00890
81