VOLTCRAFT V-CHARGE 80GPS Bedienungsanleitung Seite 72

If no error is found, e.g. the display shown on the right will appear.
The "S" value indicates the cell number that you have set in the menu (in
the example a 3-cell rechargeable battery).
The "R" value indicates the cell number that the charger has recognised (in
the example also a 3-cell rechargeable battery).
If these two numbers do not match, please check the settings on the charger and the battery itself. It may
be that the rechargeable battery has been completely discharged, or a cell may be faulty. In this case, the
battery should not be charged, as there is a risk of fire and explosion!
You can return to the previous configuration menu using the "ESC/MODE/STOP" button.
• If the two cell numbers match, briefly push the "START/ENTER" button.
• Charging process starts. The display will show various information on the
current charging progress.
Example:
At the upper left, the rechargeable battery type and the cell number are displayed ("Li3S" = Lithium rechargeable
battery with 3 cells); the charging current is shown in the upper middle and the current rechargeable battery volt-
age at the upper right.
The lower left shows the current rechargeable battery programme ("CHG" = "CHARGE"), in the middle the
elapsed charging time and the charged capacity in mAh are displayed to the right of this.
Various information is indicated on the display during a charge/discharge process by repeatedly pressing the
button "DEC" (see chapter 18). If you do not push any button for a few seconds, the charger will return to the
normal display.
• After completion of charging, an audio signal is emitted (if it has not been turned off).
If you wish to cancel the charging process, push the "ESC/MODE/STOP" button.
72
S: 3SER R: 3SER
CANCEL(EXIT)
S: 3SER R: 3SER
CONFIRM(ENTER)
Li3S 1.2A 12.32V
CHG 022:43 00682