Inhaltsverzeichnis
Werbung
GB
Electrical information
Fig. 2
D
Elements on the front side of the device – see the front side illustration
•
Socket with "-" label
NL
Connection for the earthing cable with an earthing clamp
•
Socket with "+" label
Connection for the electrode cable with an electrode clamp.
F
•
Green LED
The device is ready for operation
•
Yellow LED
E
The device has switched off due to excessive loading or overheating of the internal
semiconductors. Wait about 4 to 5 minutes until the device has cooled down. When the
yellow LED goes out and the green LED illuminates then you can continue welding.
P
•
Switch
Auniversal switch for ON/OFF (0 position), current intensity and electrode diameter.
Switching on/off produces an audible click.
I
•
Rear and sides of the device
Keep the ventilation slots clear of obstructions, and maintain at least 10 cm clearance from
walls and other surfaces.
S
2. SAFETY REGULATIONS
FIN
Explanation of symbols
N
Defective or discarded electrical or electronic devices must be deposited at
the appropriate recycling stations.
DK
Symbol for welding inverter with rectifier for DC current
EN 60974-1:
Electrical safety standard
1998 + A1 + A2
Symbol for hand arc welding
Symbol for output voltage protected against accidental touching
Uo
DC output voltage: unloaded (when not welding) 70 V max.
Symbol for mains connection. Mains frequency 50 Hz
U
Mains voltage 230 V
1
04
Ferm
Ferm
GB
D
NL
F
E
P
I
S
FIN
N
DK
105
Werbung
Inhaltsverzeichnis
