Inhaltsverzeichnis; Spare Parts List; 16A; Device Data - Ferm FWM-10/80 Gebrauchsanweisung

Spare parts list

No. Description
400920 Knob potentiometer
400921 Electrode holder
400922 Earth clamp
400923 Quick plug with cable
400924 Fan
400925 Carry belt
70V
106
Position
9
10
11
12
17
30
Serial No.
30% 30% 60% 60% 100% 100%
80A 80A 50A 50A
23,2V 23,2V
22V 22V

16A

12,5A
16 A 16 A
Ferm
ARC WELDING INVERTER
The numbers in the following text refer to the illustrations on pages 2 + 106.
Read this manual thoroughly before using the device. This will allow you to better
understand your product and avoid any unnecessary risks. Follow the safety
instructions in this manual before you use the arc welder. Store this manual in a
safe place for future reference and only give the device to other people together
with this manual.
Area of application
The device is suitable for hand welding using coated electrodes of sizes 1.6 mm Ø, 2 mm Ø and
a maximum of 2.5 mm Ø. You can use the device for welding steel sheets from 1.5 mm up to
approximately 8 mm thick.
It is intended for both private and commercial use.
Table of contents
1. Device data
2. Safety regulations
3. Assembly and first-time use
4. Operation
5. Service and maintenance

1. DEVICE DATA

Technical data and type plate symbols
Table 1 - Page 106
Scope of delivery
Fig. 1
1. Inverter
2. Power cable
3. Electrode cable with electrode clamp (+)
4. Earth cable with earth clamp (-)
5. Carrying strap
Front side
Fig. 2
6. ON/OFF, current intensity and electrode diameter switch
7. Green LED showing that the unit is ready for operation
8. Yellow LED indicating an overload/overtemperature switch-off
9. Positive (+) connection for electrode cable
10. Negative (-) connection for earthing cable
Ferm
GB
D
NL
F
E
P
I
S
FIN
N
DK
03