Switching Flame Simulator On / Off; Using The Dimmer Function; Switching Heating Function On / Off - Ruby Fires AJ55 Bedienungs- Und Sicherheitshinweise

Switching flame simulator on / off

Note: You can also switch on the flame simulator when you are not using the heating function.
Note: Power consumption of the electric fireplace insert with illumination switched on but without heating
function amounts to approx. 2 W.
• Open the right hand cover 2 by opening it up towards the front.
• Set the ON / OFF switch 9 to position I.
• Set the ON / OFF switch 9 to position 0 if you would like to turn off the flame simulator.
• Close the right hand cover 2 .

Using the dimmer function

Note: Your electric fireplace insert has a dimmer function. With it you can adjust the brightness of
the flame simulator.
Note: You can only use the dimmer function when the flame simulator is switched on (see "Switching
flame simulator on / off").
• Open the left hand cover 6 by opening it up towards the front.
• Turn the dimmer 11 in the direction of rotation to increase the brightness of the flame simulator or as
the case may be turn the dimmer 11 in the direction of rotation to reduce the brightness of the flame
simulator.

Switching heating function on / off

Note: The electric fireplace insert has 2 heating stages with different heat intensities.
• Open the right hand cover 2 by opening it up towards the front.
• Set the switch for the first heating stage 8 to position I if you would like a low supply of heat. Set the
switches for the first 8 and second heating stages 7 to positions I and II if you would like a high
supply of heat.
Note: You can only put the second heating stage into operation if the switch for the first heating stage
8 is set to position I.
ATTENTION! DANGER OF BURNING! Please observe that the surfaces which radiate heat can
achieve temperatures exceeding 50 °C. Make sure that the unit is switched off and cooled off before
you touch it.
ATTENTION! Please make sure that the unit is not covered with towels, curtains or similar objects.
Otherwise there is danger of overheating. Therefore, always pay attention that the ventilation
slots 1 are kept clear.
• Flip the switches for the first heating stage 8 and the second heating stage 7 up in order to turn of
the heating function.
8