Parkside Performance PWSAP 20-Li G7 Originalbetriebsanleitung Seite 14

GB
IE NI
position. Keep pressing the spindle lock
(11).
4. Loosen the keyless chuck (22).
You can release the spindle lock (11).
5. Disassembly: Take the attachment tool
off the mounting flange (23).
Assembly: Place the attachment tool on
the mounting flange (23).
If a direction of rotation is indicated on
the disc, this must match the direction of
rotation arrow (10)
Ensure that the attachment flange (23) is
placed on the device such a way that the
recesses in the attachment flange grip
into the edge of the device. The uptake
spindle (24) must turn simultaneously
when you turn the attachment flange.
6. Place the keyless chuck (22) on the up-
take spindle (24). The flat side of the key-
less chuck faces the attachment tool.
7. Press and hold the spindle lock (11).
8. Turn the uptake spindle (24) until the stop
button holds the uptake spindle in a fixed
position. Keep pressing the spindle lock
(11).
9. Tighten the keyless chuck (22).
You can release the spindle lock (11).
Fitting and removing the wire
brush
CAUTION! Risk of injury when
touching the attachment tool. Wear
protective gloves when handling the
attachment tool.
Tools required
• Open-end spanner (not included)
Removing the wire brushes (Fig. E)
1. Press and hold the spindle lock (11).
2. Turn the uptake spindle (24) until the stop
button holds the uptake spindle in a fixed
position. Keep pressing the spindle lock
(11).
3. Release the wire brush with an open-end
spanner.
You can release the spindle lock (11).
Fitting the wire brush (Fig. E)
1. Place the desired wire brush onto the up-
take spindle (24).
2. Press and hold the spindle lock (11).
14
3. Turn the wire brush onto the uptake
Fitting and removing the
attachment on the guard cover
.
Requirements
• Cutting disc mounted
• Battery removed from device
Fitting the attachment (Fig. C)
1. Place the attachment (13) on the guard
Removing the attachment (Fig. C)
1. Release one of the two locks (14) on the
2. Slide the released lock (14) over the
Checking the battery charge level
LEDs
red, orange, green
red, orange
red
1. Press the button (17) next to the charge
2. Charge the battery (18) when only the red
Charging the battery
See also the charger instruction manual.
Notes
• If warm, allow the battery to cool before
• Do not expose the battery to direct sun-
spindle (24). Tighten the wire brush using
a combination wrench.
You can release the spindle lock (11).
CAUTION! Risk of injury when
touching the attachment tool. Wear
protective gloves when handling the
attachment tool.
cover (8) and turn the attachment (13) un-
til it audibly clicks into place.
attachment (13) by pushing the lock (14)
outwards.
guard cover (8) until the attachment is re-
moved after half a turn.
Meaning
Battery charged
Battery partially
charged
Battery needs to be
charged
level indicator button (16) on the battery
(18).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
LED on the charge level indicator (16) is
illuminated.
charging.
light for long periods and do not place it
on a radiator (max. 50°C).