ELL Solid RG10A/BGEF Bedienungsanleitung Seite 7

Handling the Remote Controller
Inserting and Replacing Batteries
Your air conditioning unit may come with two batteries.
Put the batteries in the remote control before use.
1.
Slide the back cover from the remote control
downward, exposing the battery compartment.
2.
Insert the batteries, paying attention to match
up the (+) and (-) ends of the batteries with the
symbols inside the battery compartment.
3.
Slide the battery cover back into place.
BATTERY NOTES
For optimum product performance:
Do not mix old and new batteries, or
•
batteries of different types.
Do not leave batteries in the remote control if
•
you don't plan on using the
device for more than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted
municipal waste. Refer to local laws for proper
disposal of batteries.
TIPS FOR USING REMOTE CONTROL
•
The remote control must be used within 8 meters
of the unit.
•
The unit will beep when remote signal is received.
•
Curtains, other materials and direct sunlight can
interfere with the infrared signal receiver.
•
Remove batteries if the remote will not be used
more than 2 months.
NOTES FOR USING REMOTE CONTROL
This equipment has been tested and found to comply with
the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, w hich can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
•
Changes or modifications not approved by the
party responsible for compliance could void
user's authority to operate the equipment.
6