ELL Solid RG10A/BGEF Bedienungsanleitung Seite 39

Minimum Cross-Sectional Area of Power and
Signal Cables-For reference.
Rated Current of
Appliance (A)
> 3 and ≤ 6
> 6 and ≤ 10
> 10 and ≤ 16
> 16 and ≤ 25
> 25 and ≤ 32
> 32 and ≤ 40
CHOOSE THE RIGHT CABLE SIZE
The size of the power supply cable, signal
cable, fuse, and switch needed is determined
by the maximum current of the unit. The maximum current
is indicated on the nameplate located on the side panel of
the unit. Refer to this nameplate to choose the right cable,
fuse, or switch.
a. Using wire strippers, strip the rubber jacketfrom
both ends of the signal cable
to reveal approximately 15cm (5.9") of wire.
b. Strip the insulation from the ends.
c. Using a wire crimper, crimp u-lugs on the
ends.
NOTE: When connecting the wires, strictly follow the
wiring diagram found inside the electrical box cover.
1.
Remove the electric cover of the outdoor unit. If there
is no cover on the outdoor
unit, take off the bolts from the maintenance boardand
remove the protection board.
2. Connect the u-lugs to the terminals
Match the wire colors/labels with the labels on the
terminal block. Firmly screw the u-lug of each wire to
its corresponding terminal.
3. Clamp down the cable with the cable clamp.
4. Insulate unused wires with electrical tape.
Keep them away from any electrical or metal parts.
5. Reinstall the cover of the electric control box.
Nominal Cross-Sectional
Area (mm2)
0.75
1
1.5
2.5
4
6
Cover
Screw
INDOOR UNIT WIRING
1. Prepare the cable for connection
a. Using wire strippers, strip the rubber jacket from
both ends of the signal cable
to reveal about 15cm (5.9") of the wire.
b. Strip the insulation from the ends of the wires.
c. Using a wire crimper, crimp the u-lugs to the ends
of the wires.
2.
Pull the left and right handles of the front, panel,
pull the panel outward, and open the panel.
3.
Remove the electric control box.
4. Connect the u-lugs to the terminals.
Match the wire colors/labels with the labels on the
terminal block, Firmly screw the u-lug of each wire
to its corresponding terminal. Refer to the Serial
Number and Wiring Diagram located on the cover
of the electric control box.
This wires is just
for test.Please remove
while installation.
38
Electric
control box
Wiring diagram