ELL Solid RG10A/BGEF Bedienungsanleitung Seite 16

CAUTION
• Before changing the filter or cleaning, turn off the unit
and disconnect its power supply.
• When removing filter, do not touch metal
parts in the unit. The sharp metal edges can
cut you.
• Do not use water to clean the inside of the indoor unit.
This can destroy insulation and
cause electrical shock.
• Do not expose filter to direct sunlight when drying. This
can shrink the filter.
• Any maintenance and cleaning of outdoor
unit should be performed by an authorized dealer or a
licensed service provider.
• Any unit repairs should be performed by an authorized
dealer or a licensed service provider.
Maintenance your AC.
Maintenance –
Long Periods of Non-Use
If you plan not to use your air conditioner for an
extended period of time, do the following:
Clean all filters
T urn off the unit and
disconnect the power
NOTE:
Do not stretch or hang objects at the air outlet.
Do not adjust the automatic air deflector by hand or extend your hand into the air duct. Do not cover
the air inlet and outlet of the unit with objects.
T urn on FAN function until
unit dries out completely
Remove batteries from
remote control
Replace internal parts
1. Pull the left and right handles of the front panel , pull the
panel outward, and open the panel.
2. Remove the 7 screws on the face frame.
3. Buckle up the snap indicated by the arrow and remove
the face frame.
4. Replace internal parts.
5. Install the face frame and panel parts.
Maintenance –
Pre-Season Inspection
After long periods of non-use, or before periods of frequent
use, do the following:
Check for damaged wires
Make sure nothing is blocking
all air inlets and outlets
15
Clean all filters Check for leaks
Replace batteries