ELL Solid RG10A/BGEF Bedienungsanleitung Seite 13

ECO/GEAR function
Press this button to enter the energy efficient mode in a sequence of following:
ECO
Note: This function is only available under COOL mode.
ECO operation:
Under cooling mode, press this button, the remote
controller will adjust the temperature automatically to 24°
C/75°F, fan speed of Auto to save energy (only when the
set temperature is less than
24°C/75°F). If the set temperature is above
24°C/75°F, press the ECO button, the fan speed
will change to Auto, the set temperature will remain
unchanged.
GEAR operation:
Press the ECO/GEAR button to enter the GEAR operation as following:
75%(up to 75% electrial energy consumption)
Previous setting mode.
Under GEAR operation, the display on the remote controller will alternate between electical energy consumption
and set temperature.
Silence function
2s
Keep pressing Fan button for more than 2 seconds to activate/disable Silence function.
Due to low frequency operation of compressor, it may result in insufficient cooling and
heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean button while operating will
silence function.
FP function (Frost protection)
Press this button 2 times during one second under HEAT Mode and setting temperature of 16°C/60°F to activate
the FP function.
x2
The unit will operate at high fan speed (while compressor on) with temperature
automatically set to 8°C/46°F.
GEAR(75%) GEAR(50%)
50%(up to 50% electrial energy consumption)
Previous setting mode ECO......
NOTE: Pressing the ECO button, or modifying the
mode or adjusting the set temperature to less than
24°C/75°F will stop ECO operation. Under ECO
operation, the set tmeperature should be 24°C/75°F
or above, it may result in insufficient cooling. If you feel
uncomfortable, just press the ECO button again to
stop it.
12
cancel