ELL Solid RG10A/BGEF Bedienungsanleitung Seite 28

2 Installing the main body
After loosening the screws, remove the mounting plate from the unit.
Fix the mounting plate with a tapping screw onto the wall.
NOTE: It is recommended to fix it on the wall according to the hanging hole indicated by the arrow on the
mounting plate. Mounting plate must be installed horizontally.
Hang the indoor unit on the mounting plate (The bottom of body can touch the floor or remain suspended, but the
body must be installed vertically ).
NOTE:
After installation, the unit shall
be kept horizontal without tilting.
Remove the
mounting plate
Loosen the screw
Loosen the
screws(Only for left
outlet pipe)
27
Mounting plate
T apping
screw
Washer
<6mm