Cleaning And Storing The Device - Cleanmaxx Pc-P017 Gebrauchsanleitung

• To pull a nozzle or the extension tube
out again, press the release button (24).
2. Switch on the device and guide the
nozzle over the area to be cleaned. To
switch on at suction level 1, press the
On / Off button (12). You can press
the button (13) to switch between
suction level 1 and 2.
The selected suction level is indicated by
the colour of the function lamp (11):
Suction level 1 – lights up blue
Suction level 2 – lights up purple
3. To switch off the device, press the
On / Off button.
4. To ensure optimum performance of the
device, empty and if necessary clean the
dust container after every use (see next
chapter).
CLEANING AND STORING
THE DEVICE
Please Note!
■ Do not use any sharp or abrasive
cleaning agents for cleaning. They may
damage the surfaces.
L
The filters may lose some of their
colour over time. This is normal and
does not have any adverse effect on
function.
Emptying the Dust Container
1. Take off the extension tube (5) if it is
located on the device.
2. Hold the dust container (22) over an
open dustbin and press the button for
opening the dust container flap (21).
The dust container flap (18) opens (Pic-
ture F) and the dirt drops out.
3. To close it, press the dust container
flap onto the dust container. You must
hear it engage.
13769_Inlay_de-en-fr-nl_A5_V1.indb 17 13769_Inlay_de-en-fr-nl_A5_V1.indb 17
Cleaning the Dust Container, Metal
Filter and EPA11 Filter
1. Open the dust container, reach in and
twist the bottom of the metal filter (19)
a little anticlockwise until it is detached
from the device.
2. Take the metal filter out of the dust
container.
3. Pull the EPA11 filter (20) out of the
metal filter.
4. Tap out both filters and clean them with
a soft brush if necessary. They can also
be rinsed out with clear water, but they
must be completely dry before they
are assembled!
5. Wipe the dust container with a damp
cloth if necessary and then dry it or
allow it to dry in the air.
6. When all components are dry, insert the
EPA11 filter into the metal filter.
7. Insert the metal filter into the dust con­
tainer and twist it clockwise to secure it.
8. Close the dust container.
Cleaning the Exhaust Air Filter
1. Twist the filter compartment cover (26)
anticlockwise and take it off.
2. Pull the exhaust air filter out of the
exhaust air filter compartment (25).
3. Tap out and brush out the exhaust air fil­
ter and the exhaust air filter compartment.
The exhaust air filter can also be rinsed
out with clear water, but it must be
completely dry before it is assembled!
4. Insert the cleaned exhaust air filter into
the exhaust air filter compartment.
5. Place the filter compartment cover on
and twist it clockwise to secure it.
Cleaning the Motor Unit, Extension
Tube and Nozzles
• Wipe down the motor unit (4),
the extension tube (5) and the
nozzles (3, 6, 9) with a damp cloth if
necessary. Then wipe them dry.
• Remove hair and fluff from the nozzles
and brushes.
EN
17
10.11.2023 12:41:36 10.11.2023 12:41:36