Accessories; Use - Cleanmaxx Pc-P017 Gebrauchsanleitung

EN
Screwing On the Wall Mounting
Bracket
1. Place the wall mounting bracket straight
against the wall and mark out two drill
holes.
2. Drill holes into the wall and place an­
chors in them.
3. Screw on the wall mounting bracket.

ACCESSORIES

Floor Nozzle
The floor nozzle (9) is suitable for both
carpets and smooth floors. The foot pedal
can be used to switch between carpet and
smooth floor. A brush folds out on the
underside of the floor nozzle for smooth
floors.
Brush Nozzle
The brush nozzle (6) has a rotatable brush
head. Rotate the brush head into the
position you want to adjust the angle of
the nozzle opening (Picture C). The nozzle
is suitable for dusting all uneven objects,
furniture, lamp shades, picture frames,
keyboards, books etc.
Crevice Nozzle
The crevice nozzle (3) is ideal for places
which are hard to get to, such as corners,
crevices or recesses as well as upholstery
and all nooks and crannies that cannot be
reached with other nozzles.
Nozzle Adapter, short
The short nozzle adapter (1) is required to
attach the extension tube (5) to the motor
unit (4).
It also can be used to attach the floor
nozzle (9) directly to the motor unit without
using the extension tube.
Nozzle Adapter, long
The long nozzle adapter (2) is required
to attach the crevice nozzle (3) and brush
nozzle (6) on the extension tube (5). Both
16
13769_Inlay_de-en-fr-nl_A5_V1.indb 16 13769_Inlay_de-en-fr-nl_A5_V1.indb 16
nozzles can be attached to the motor
unit (4) directly.
Extension Tube
The extension tube (5) is intended to be
used with the floor nozzle for cleaning
floors (Picture D). In addition, it makes it
easier to reach ceilings and corners.
Nozzle Holder
The crevice nozzle and brush nozzle can
be plugged onto the nozzle holder (7) for
storage. This is clamped onto the extension
tube (Picture E).

USE

Please Note!
■ Ensure that there are no larger, sharp
objects on the surface which is to be
cleaned.
■ While using the device, make sure that
the dust container does not get too
full. Empty the dust container regularly
and clean it after every use. Regularly
clean the filters as well to prevent the
motor from being overloaded (see the
"Cleaning and Storage" chapter).
■ Switch off the device after you finish
cleaning each surface to significantly
increase the operating time on each
battery charge. Charge up the battery
after use (see the "Charging Up the
Battery" chapter).
L
The device cannot be operated
when it is connected to the mains
power. Disconnect the connecting
cable (10) prior to use.
1. Select a nozzle (see the "Accessories"
chapter) and plug it into the suction
opening (23). You must hear it engage.
For a longer reach, plug the extension
tube (5) in between.
10.11.2023 12:41:35 10.11.2023 12:41:35