Charging Up The Battery; Wall Mounting Bracket - Cleanmaxx Pc-P017 Gebrauchsanleitung

be damaged! If dirt were to get inside
the motor unit, this could damage the
motor.
■ The device must be switched off when
the power supply is pulled out or inser­
ted into the plug socket. Always pull the
power supply and never the mains cable
to disconnect the device from the mains
power!
■ Do not place heavy objects on the de­
vice or the connecting cable.
■ Protect the device from heat, flames,
extreme temperatures, persistent mois­
ture and impacts.
■ Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage. The LEDs
cannot be replaced.
■ Remove a dead battery from the device
immediately. Clean the contacts before a
new battery is inserted.
CHARGING UP THE
BATTERY
Please Note!
■ It is essential that you charge up
the battery fully before you first use
the device in order to achieve the
maximum charging capacity. If the
battery is fully discharged during use, it
must be fully charged up again before it
is next used.
■ Only connect the power supply to a plug
socket that is properly installed and mat­
ches its technical data. The plug socket
must be readily accessible after connec­
tion so that the connection to the mains
can quickly be isolated.
■ Only use suitable extension cables who­
se technical data is the same as that of
the power supply.
13769_Inlay_de-en-fr-nl_A5_V1.indb 15 13769_Inlay_de-en-fr-nl_A5_V1.indb 15
■ Pull the power supply out of the plug
socket if an error occurs during charging
or before a thunderstorm.
1. Plug the barrel connector of the con­
necting cable (10) into the charging
socket (16).
2. Connect the power supply to a plug
socket.
The charge control lamps (15) start to
flash and the battery (17) is charging.
If all charge control lamps are constantly
lit, the battery is fully charged.
WALL MOUNTING
BRACKET
Please Note!
■ Use the fixings which are also supplied
to hang up the wall mounting bracket.
If you are unsure whether the fixings
supplied are suitable for the wall, seek
advice from a specialist retailer.
■ Hang the wall mounting bracket in
a secure and fixed position.
■ Before drilling, ensure that there are
no pipes or power cables behind the
intended drilling point.
The device can be stored in the wall moun­
ting bracket (8) and charged up there for its
next use (Picture E).
L
Ideally attach the wall mounting
bracket near to an easily accessible
plug socket so that the device can be
charged.
The cord of the connecting
cable (10) can be tucked in on the
small hook on the wall mounting
bracket.
EN
15
10.11.2023 12:41:35 10.11.2023 12:41:35