Gima NE-M01 Gebrauchsanweisung Seite 22

● Keep the device out of the reach of children.
● Do not store the device in places such as direct sunlight, high temperature, humid, dusty or easy to get
to water, etc.
● Avoid the device from slope, vibration or shocked.
● Transportation adopts general transportation means or follows the contract requirements. Avoid violent
shock, vibration, rain and snow splash during the process of transportation.
5.4 Pollution-free disposal and recycle
The service life of product is 10 years. If the device exceeds the period of use, it must be discarded. Please
contact the manufacturer or distributor for more information.
1) The atomizer out of use can be sent back to the manufacturer or distributor for proper recycling.
2) Used parts can be returned to the manufacturer or distributor for disposal, or in accordance with rele-
vant laws and regulations.
3) Used masks can be treated in accordance with relevant laws and regulations.
CHAPTER 6 - TROUBLESHOOTING
Problems
The device can't
startup.
No atomizing or little
atomizing appears
when device working.
There is water around
the nozzle of nebulizer.
After startup, power
indicator lights about
1s, then immediately
goes out.
After turning on the
device, the power
indicator lights once,
then it is out
immediately or the
device can not work
normally.
Nebulizer doesn't
automatically
shutdown when
medication is used up.
If the device still can't work normally after doing all methods above, pleas contact our after-sales service.
ENGLISH
Reason analysis
Battery is not well installed.
Medication cup is not well installed.
No medication in medication cup
Improper medication
The nebulizing sheet is dirty
Excessive bubble formation in medication
Due to temperature differences, the
temperature of medication cup surface is
relative low, medication mist in contact
with the nozzle, then condenses into water
droplets.
Medication cup is not well installed.
Medication cup is not loaded with any
medication
The battery had run down.
Medication may generate bubbles in
medication cup
Medication may attached on the
nebulizing sheet
The electrodes contacting with the
medication cup may be dirty
Solutions
Check the installation of battery, and
reinstall the batteries.
Check the installation of medication cup,
and reinstall it.
Trickle medication into medication cup,
remember do not exceed its maximum
capacity.
Consult a doctor if the medication is
suitable for the device.
Clean medication cup.
Adjust the holding angle and gently shake
the nebulizer until aerosol is generated
Remove medication cup, pour the water
out.
Install medication cup once again.
Put the medication into medication cup
after consulting your doctor.
Replace the batteries immediately.
Press "ON/OFF" button to turn off the
device, and clear up the bubbles.
Press "ON/OFF" button to turn off the
device, and clean medication cup.
Press "ON/OFF" button to turn off the
device, and clean the electrodes.
22