Grundig R 2000 Bedienungsanleitung Seite 11

@ r Receive R2000
O Power switdl for switching on and off
(bottom on)
O Bass control
O Presence control (medium tones)
O Treble control
O Stereo balance
O Programme buttons (for FM station
selection with tuning knob
also the small button O)
e Tape socket TB/TAPE 2
O Monitor switch (Set to bottom only
for tape monitoring)
O Switdl for muted tuning on VHF/FMi
bottom — on
O MPX switch (set to bottom position for
stereo reception)
O AFC switch. bottom
Loudspeaker group swiW1es
O Connections for stereo headphones
(6.3-mm jack plugs)
O Knob for manual tuning
O Controls for FM station presetting
(adjusting key can be stored to the
right of the controls)
0 VHF/FM station buttons 1
LED indication for stereo reception
Numerical display Of selected
button
"Tunoscopee indicator
tuning on FM
LED tuning indicator
strength indication)
O Small U button, must be depressed
FM station selection
knop O
Volume control
O
Linear swit&l
O Connectionsfor AM aerial (LW, MW) Y,
earth + and FM dipole (300 Q)
O Coaxial socket for 75 ohm aerial
Connection for record player with
magnetic pick-up
Sensitivity switch for phono input O
O Connection for tape/cassette
or record player with ceramic/crystal
pick-up (TB/TAPE
Connection for an additional
cassette recorder
Line output (high-level voltage output)
Monitor
press
on
7
station
for exact centre
(on FM, field
for
with tuning
recorder
1)
tape/
(TB/TAPE 2)
O Connections for loudspeaker
LS 1 (R = right channel,
dlannel)
Connections for loudspeaker
Installation
If HiFi components in a rack or cabinet
(Compact-system) are to function
I. e. without excessive
heat and reciprocal
must be strictly observed.
Depending on tho number and combination
of the employed HiFi components,
are to be placed one above the other into
the rack (Compact-System)
pattern below:
Record player (PS)
Receiver (R)
Cassette ded( (CF)
This is the maximum
ponents that can be installed.
other set is deleted,
sets in the sequence
valid for free installation.
Mains cables must not be placed near AF
leads, like connection
player, cassette ded(. tuner or
loudspeakers.
In the GRUNDIG HiFi range you will find
the appropriate radg
Systems for your GRUNDIG
Your dealer will be glad to advise you.
Mains Connection
The set is designed
AC mains supply of 220 V (50/60 Hz).
Addltlonal Information
In Great Britain
The set is designed to operate from
a mains supply of 240 V AC. We
recommend that a 13 amp 3-pin plug
fitted with a 2 amp fuse be used. The
brown lead should
the live pin (marked 'L' or 'red' or
'brown') and the blue lead must be
connected to the neutral pin (marked
'N' or 'blade or 'blue'). On no account
should either of the wires
to tho earth pin (marked 'E' or 'green/
yellow'). If other mains plugs are
used, ensure that they are protected
with a 2 amp fuse.
We recommend that the set be
disconnected from
In use for long periods.
group
L — left
group
property,
accumulation of
effects. the following
they
as shown in the
number of com-
If one or the
leave the remaining
indicated. Same is
leads of record
and Compact-
HiFi units.
to operate from an
for sets sold
be connected to
be connected
the mains when not