Setting The Rotational Direction; Switching On/Off; Speed Control; Led Work Light - Parkside Performance Pdssap 20-Li D3 Bedienungsanleitung

˜ Switching on/off
WARNING! Risk of injury due
m
to unintentional continuous
operation of the product!
Before inserting the battery pack
u
check that the on/off switch
works properly and returns to the
OFF position when released .
Switching on
1 . Insert the battery pack
"Inserting/removing the battery pack").
2 . Set the rotational direction (see

"Setting the rotational direction").

3 . Select the speed level (see "Selecting
the speed level").
4 . Press and hold the on/off switch
Switching off
1 . Release the on/off switch
2 . Wait until the product has stopped
before placing it down .
3 . When taking a break: Push the
rotational direction switch
middle position . This prevents the
product from being switched on
accidentally .
4 . Remove the battery pack
product if you are leaving the product
unattended or if you have finished
working .
˜ Speed control
Progressively controlling the speed:
o
Apply gentle or stronger pressure on
the on/off switch
Pressure
Gentle
Strong
18 GB
[ 6 ]
[ 14 ]
(see
6 ] [
.
[ 14 ]
.
14 ] [
to the
3 ] [
from the
[ 6 ]
.
[ 14 ]
Speed
Low
High
˜ LED work light
NOTE
Improve visibility in poorly lit areas:
u
This product is equipped with a
LED work light
,
immediate working area .
As soon as the product is switched
on: The LED work light
immediately .
˜ Belt clip
CAUTION! Risk of injury!
m
Before hanging the product on a
u
belt: Push the rotational direction
switch
[ 3 ]
This prevents the product from being
switched on accidentally .
Hanging the product on a belt: Use the
o
belt clip
[ 7 ]
You can use the belt clip
opener for bottles with crown caps .
˜ Working instructions
NOTICE!
m
Always follow the manufacturer's
u
instructions for tightening screws
or nuts . Follow the manufacturer's
guidelines for the inspection of
screws or nuts in accordance with
time or performance .
After changing a vehicle's wheel(s):
u
Inspect the wheel bolts or nuts as
requested in the manufacturer's
instructions or guidelines . Tighten
the wheel bolts or nuts with a torque
wrench after approx. 50 to 100 km.
to illuminate the
11 ] [
switches on
11 ] [
to the middle position .
.
as a bottle
7 ] [