React AIR Bedienungsanleitung Seite 28

Cord Inspection:
1. The handle cords can be easily inspected by pulling the handles all the way out and
visually checking for wear.
2. Inspect the cords working inside the vertical frame. Start by removing the lower right
side cover by removing 8 screws, using the 6 lobe. Once the cover is removed all cords
and pulleys will be visible.
3. Have a helper slowly pull the handles, all the way out and observe the condition of the
handle, cords and the bungee cord. You should be able to see the entire working length
of all cords.
Inspect the Fasteners
Be sure all fasteners are tight and have not become loose during use.
Inspect the Top Bracket Pulleys
Be sure the pulleys spin freely in the pulley housings and that the pulley housing swing
freely in the pulley brackets.