VEVOR MS3126 Handbuch Seite 22

6. Lift up on the same clamping device from Step 5, then insert the end of the
replacement strip so that it fills as much of the slot as possible and is aligned with
the left side of the slot.
Note: Align the direction arrows printed on the bottom of sandpapaer with
the drum's rotation direction.
7. Release the clamping device to hold the strip in place, then tug on it to make
sure it is secure.
If the sandpaper strip comes loose during operation, it could
cause the workpiece to bind and kickback at the operator, which
could result in serious personal injury. Always make sure the
sandpaper strip is properly installed and firmly secured by the clamping
devices before connecting the sander to power.
8. While keeping reasonable tension on the strip with one hand, roll the drum away
from you with the other hand to wrap the strip onto the drum.
IMPORTANT: When wrapping the strip onto the drum, a minimum 1
⁄8" gap between the edges may be necessary, but do not overlap.
Additionally, make sure that the strip remains tight without any slack. DO
NOT overlap the sandpaper. The sandpaper should be flush or
slightly gapped in between.
9. To secure the right end of the strip, move the clamping device forward by
pressing against the spring lever until you can insert the strip between clamp and
the spring lever.
\