Screwing The Housing To The Mounting Plate; Connecting The Multi Sensor - Sika Rcm 880 Betriebsanleitung

RCM 880 / 890

4.5 Screwing the Housing to the Mounting Plate

 Attach the room condition monitor to the
mounting plate using the four supplied
washers ( see alignment in figures) and
screws (M5) (tightening torque: 2 Nm).

4.6 Connecting the Multi Sensor

 Remove the yellow ESD protection cap of the multi sensor.
 Connect the round plug of the multi sensor to the sensor input
monitor.
 Tighten the knurled nut hand-tight.
Technical changes reserved
Installing and Connecting the RCM 880 / 890

of the room condition
- 37 -