KTM 660 RALLY 2004 Bedienungsanleitung Seite 30

30
2
3
1
2
5
4
6
– Position the float, mount the float hinge pin and secure it by means of
the screw.
– Check the float level.
– Stick the plastic component
2
– Engage the push rod of the accelerator pump at the lever.
– Mount the float chamber and at first secure it with only 1 screw. When
positioning the float chamber, make sure that the push rod
accelerator pump slides into the bore.
3
– Place the membrane with the labeling facing upwards and the spring
into the pump housing.
4
– Place the O-ring into the groove. Secure the sealing ring
grease in the cover and fasten the cover by means of 3 screws.
– Turn the cable disc and push the throttle valve into the carburetor such
6
that the rollers engage the throttle valve (see photo). Push the throttle
valve all the way into the carburetor.
– Turn the cable disc several times and while doing so check whether the
throttle valve moves smoothly.
1
on the needle jet.
2
of the
5
with some