KTM 660 RALLY 2004 Bedienungsanleitung Seite 21

Change engine oil, replace oil filter, fine filter and microfilter *
Bleeding of the oil system *
NOTE: The frame breast pipe is integrated into the oil circuit for the sake of
1
more effectively cooling the motor oil. It is thus important when changing
2
the oil to also remove the fine screen filter, to drain the motor oil from the
breast pipe and to de-aerate the oil system.
If the oil system is not bled at all or bled insufficiently, the bearings of the
engine will not get enough lubrication, which in turn may result in engine
failure.
Therefore, we recommend that you have the engine oil changed by your
A
3
authorized KTM mechanic. During the guaranty period, the oil change must
be performed by an authorized KTM mechanic. Otherwise, the guarantee
will become void.
The engine oil change is to be carried out when the engine is still warm.
WARNING
A , -
N ENGINE HAVING BEEN RUN WARM AND THE ENGINE OIL IN IT IS VERY HOT DO NOT
.
5 BURN YOURSELF
Place the motorcycle on an even surface and remove the underride protec-
4 1 2 3
tion . Remove the three plugs , and and allow the oil to drain into
a suitable vessel.
! !
CAUTION
A
P , - .
LUG MUST NOT BE REMOVED THIS IS PART OF THE BY PASS VALVE
5
Loosen the fine screen filter with an oil filter wrench and then screw it off
4
21
by hand.
6
The screw must be removed to allow the motor oil to flow out of the
frame breast pipe.
6
Remove the right front fuel tank. Loosen the two HH screws 7 and remove
the microfilter cover.
7
7
8
Remove the microfilter . Insert a new microfilter. Clean the sealing area
and remount the microfilter cover.
8