Manufacturer's Information; Delivery; Transport; Storage - Gemü R480 Victoria Betriebsanleitung

9 Manufacturer's information

9 Manufacturer's information

9.1 Delivery

● Check that all parts are present and check for any damage
immediately upon receipt.
The product's performance is tested at the factory. The scope
of delivery is apparent from the dispatch documents and the
design from the order number.

9.2 Transport

1. Only transport the product by suitable means. Do not drop.
Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal regu-
lations / environmental protection laws.

9.3 Storage

1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their spare
parts.

10 Installation in piping

10.1 Preparing for installation

The equipment is subject to pressure!
▶ Risk of severe injury or death
Depressurize the plant or plant component.
●
Completely drain the plant or plant component.
●
Corrosive chemicals!
▶ Risk of caustic burns
Wear appropriate protective gear.
●
Completely drain the plant.
●
GEMÜ products without an actuating ele-
ment!
▶ Risk of severe injury or death
Do not apply pressure to GEMÜ
●
products installed in piping without an
actuating element.
Hot plant components!
▶ Risk of burns
Only work on plant that has cooled
●
down.
GEMÜ R480 Victoria
WARNING
WARNING
WARNING
CAUTION
Leakage!
▶ Emission of dangerous materials
Provide precautionary measures against exceeding the
●
maximum permitted pressures caused by pressure
surges (water hammer).
Exceeding the maximum permissible pressure!
▶ Damage to the product
Provide precautionary measures against exceeding the
●
maximum permitted pressures caused by pressure
surges (water hammer).
Use as an end-of-line valve!
▶ Damage to the GEMÜ product
●
Risk of crushing!
▶ Risk of severe injury
●
Risk of crushing!
▶ Severe injury due to crushing of the fin-
●
●
●
76 / 92
CAUTION
CAUTION
CAUTION
When using the GEMÜ product as an
end-of-line valve, a mating flange must
be fitted.
CAUTION
Before performing any work on the
GEMÜ product, depressurize the plant.
CAUTION
gers between the valve body and but-
terfly disc.
Depressurize the plant before perform-
ing any work on the butterfly valve, and
unscrew the control medium line(s) of
the butterfly valve.
Ensure that the butterfly disc is in the
respective end position (closed for NC
or open for NO).
Do not reach into the crushing area
between the valve body and butterfly
disc.
www.gemu-group.com