Safety Information; Product Description; Construction; Description - Gemü R480 Victoria Betriebsanleitung

2 Safety information

2 Safety information
The safety information in this document refers only to an indi-
vidual product. Potentially dangerous conditions can arise in
combination with other plant components, which need to be
considered on the basis of a risk analysis. The operator is re-
sponsible for the production of the risk analysis and for com-
pliance with the resulting precautionary measures and re-
gional safety regulations.
The document contains fundamental safety information that
must be observed during commissioning, operation and main-
tenance. Non-compliance with these instructions may cause:
- Personal hazard due to electrical, mechanical and chemical
effects.
- Hazard to nearby equipment.
- Failure of important functions.
- Hazard to the environment due to the leakage of dangerous
substances.
The safety information does not take into account:
- Unexpected incidents and events, which may occur during
installation, operation and maintenance.
- Local safety regulations which must be adhered to by the
operator and by any additional installation personnel.
Prior to commissioning:
1. Transport and store the product correctly.
2. Do not paint the bolts and plastic parts of the product.
3. Carry out installation and commissioning using trained
personnel.
4. Provide adequate training for installation and operating
personnel.
5. Ensure that the contents of the document have been fully
understood by the responsible personnel.
6. Define the areas of responsibility.
7. Observe the safety data sheets.
8. Observe the safety regulations for the media used.
During operation:
9. Keep this document available at the place of use.
10. Observe the safety information.
11. Operate the product in accordance with this document.
12. Operate the product in accordance with the specifications.
13. Maintain the product correctly.
14. Do not carry out any maintenance work and repairs not de-
scribed in this document without consulting the manufac-
turer first.
In cases of uncertainty:
15. Consult the nearest GEMÜ sales office.
GEMÜ R480 Victoria

3 Product description

3.1 Construction

8
7
8
2
3
6
Item Name
1 Body
2 Shaft
3 Axis
4 Disc
5 Liner
6 Threaded plug
7 O-ring
8 Support rings
9 Hexagon head bolts
0 Earthing kit for ATEX ver-
sion
0-1 Cable lug
0-2 Stranded wire

3.2 Description

The GEMÜ R480 Victoria soft seated metal butterfly valve is
equipped with a bare shaft with top flange in accordance with
EN ISO 5211. The butterfly valve is available in nominal sizes
DN 50 to 300 and in standardized installation lengths ISO
5752/20 | EN 558-1/20 | API 609 category A (DIN 3202 K1) in
wafer and lug body versions.

3.3 Function

The product controls a flowing medium after a manual, pneu-
matic or motorized actuator has been mounted.
48 / 92
9
0-1
10
0-2
5
1
Materials
SG iron 5.3106, epoxy
coated (RAL 5021)
1.4021
1.4021
Various materials (see or-
der data)
Various materials (see or-
der data)
1.4021
NBR
PTFE
Stainless steel A2-70
www.gemu-group.com
4