Cleaning And Care; Cleaning; Maintenance; Repair - Parkside Performance Paesp 20-Li A2 Bedienungsanleitung

CAUTION! Risk of injury and
m
damage to property!
Always make sure that the
u
workplace is well ventilated.
Avoid over-stressing the product
u
while working.
Use appropriate sand grid
u
working different materials.
Switch the product on before
u
applying the product to the
workpiece.
Apply minimal pressure when
u
working.
Work at a constant speed.
u
Never use the same sand grid
u
for sanding different materials (e.g.
wood followed by metal). Optimum
sanding results can only be
achieved by using clean sand grid.
Guide the product over the
u
workpiece in parallel. Use
overlapping sanding motions.
After completing the task: Lift
u
the product from the workpiece.
Switch the product off.
˜ Cleaning and care
WARNING! Risk of injury!
m
Always switch the product off,
remove the battery pack
and let the product cool
down before making any
adjustments.
˜ Cleaning
NOTE
Do not use chemical, alkaline,
u
abrasive or other aggressive
detergents or disinfectants to
clean this product as they might be
harmful to its surfaces.
Never allow fluids to get into the
product.
Always keep the product clean, dry
o
and free from oil or grease.
After each use and before storage:
o
Remove debris from the product.
Regular and proper cleaning helps to
o
ensure safe use and prolongs the life
for
[ ]
of the product.
Cleaning the product
Clean the product with a dry cloth.
o
Use a soft brush for areas that are
o
hard to reach.
In particular, clean the air vents after
o
every use with a cloth and soft brush.
The vents must always be clear.
[ ]
Cleaning the dust box
(Fig. G, H)
For a thorough cleaning: Open the
o
dust box
Use a slotted screwdriver to push the
o
clip
of the dust box
box thoroughly.
˜ Maintenance
Before and after each use: Check the
o
product and accessories for wear
and damage. If required, replace
worn or damaged accessories.
Observe the technical requirements
(see "Technical data").
Check covers and safety devices
[ 6 ]
o
for sound condition and correct
installation. If that is not the case,
have them replaced by an expert.
Change the sand grid
o
˜ Repair
This product does not contain any
o
parts that can be repaired by the
user.
Contact an authorised service centre
o
or a similarly qualified person to have
the product checked and repaired.
.
2 ] [
down and away from the slot
[ ]
. Empty the dust
2 ] [
[
regularly.
]
GB/IE 35