Only use tested, fibre reinforced cutting or
¾
grinding wheels .
Always work at a low forward speed . Apply
¾
only moderate pressure to the workpiece .
Always use up (conventional) milling . This
¾
will prevent loss of the product when it leaves
the cut .
Cleaning and care
m
WARNING!
Always switch the product off, remove
the battery pack 5 and let the
product cool down before performing
inspection, maintenance and cleaning
work!
Cleaning
Never allow fluids to get into the product .
¾
The product must always be kept clean, dry
¾
and free from oil or grease . Remove debris
from it after each use and before storage .
Regular and proper cleaning will help ensure
¾
safe use and prolong the life of the product .
Clean the product with a dry cloth . Use a
¾
soft brush for areas that are hard to reach .
In particular clean the air vents after every
¾
use with a cloth and soft brush .
The vents must always be clear .
¾
NOTE
Do not use chemical, alkaline, abrasive
u
or other aggressive detergents or
disinfectants to clean this product as they
might be harmful to its surfaces .
Maintenance
The product is maintenance-free .
¾
Before and after each use, check the product
¾
and accessories (e .g . accessory tools) for
wear and damage . If required, exchange
them for new ones as described in this
instruction manual . Observe the technical
requirements (see "Technical data") .
Repair
This product does not contain any parts that can
be repaired by the user . Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired .
Storage
Switch the product off .
¾
Clean the product as described above .
¾
Store the product and its accessories in a
¾
dark, dry, frost-free, well-ventilated place .
Always store the product in a place that is
¾
inaccessible to children . The ideal long term
storage (longer than 3 months) temperature
is between +20 and +26 °C .
Store the product in its case 22 .
¾
Grinding wheels must be dry and stored
¾
upright, and should never be stacked .
GB/CY
25